Same power with H2205-2633KV with IMPROVED V2 bell for better reliability, preventing motor bell bend and fly out mid flight.
Interchangable with H2205-2633KV V1
This H2205 V2 stands between 1806 and 2206 motor, for those who needs higher thrust than 1806 motor but less weight than 2206. This 2633KV is suitable for both
4 inch propeller on 3-4S
5 inch propeller on 3-4S
Tested with HQ5x4x3 at max thrust of 945g
It assembled with Imported NMB Bearing and Copper Wire to maintain the quality. The motor has been balanced by Motion Balancing Machine so you will see the colored balancing mud in the motor.
Quality Motor Best for 210-250 frames
Weight: Approx. 24-25g (net weight included long AWG cables)
you can lower the weight if you shorten the long AWG cables.
AWG Cable: 15cm
Prop Shaft Diameter: 5mm(CW)
Stator Diameter: 22mm
Stator Length: 5mm
Shaft Diameter: 3mm
Motor Dimensions: Φ26.6*15.3mm
ldle Current: 0.86A @ 10V
Internal Resistance: 0.081Ω
Suitable ESC: 10-30A (depends on the propeller and battery you use)
HobbyWing's XRotor works pretty well with H2205 motor so it is recommended especially the XRotor 20A is small in size as small as some 10A-12A ESC.
Since SimonK and BLHeli might shutter during high RPM on small props (eg. 5030). So if you plan to drive the motor hard, please consider to get XRotor 20A or 40A because XRotor was tested at high RPM without any sync issue.
Suitable Battery: 3-4S Li-Po (refer to thrust test table and videos)
1 x RCX H2205-6 26330KV Micro Outrunner Brushless Motor